Custom Automated Prosthetics
Home » Archive by category "CAD/CAM" (Page 3)

CAD/CAM

Formlabs Digital Factory

Formlabs Digital Factory
MIT & FormLabs sponsored a “Digital Factory” event at MIT that was well attended. I would guess there were 1,500 people and about 10 companies providing very intriguing digital industrial … Continued
Read More

Ti Bases with Adjustable Heights

Ti Bases with Adjustable Heights
Open Implants (OI), was founded on the premise of developing implant components with superior geometric configurations to all existing solutions, thus providing more predictable restorations through both analog and digital … Continued
Read More

The Sheffield Test for Implant Models

The Sheffield Test for Implant Models
Confirming the accuracy of the analog model for implant bridges or implant bar cases is a critical cost saving piece of the protocol. This is especially necessary for screw retained … Continued
Read More

The Value of a CAD Verification Bridge

The Value of a CAD Verification Bridge
  There is no doubt you’ve heard the phrase used in carpentry “measure twice, cut once” – this is a good standard for complex dental prosthetics. When fabricating a long span … Continued
Read More
  • Contact Us

    Phone: 877-977-7889

    Support hours are from 8am - 8pm EST

    Email: customercare@cap-us.com

    Stoneham
    85 Maple Street, Stoneham, MA 02180

    Clearwater
    1155 NE Cleveland St. Clearwater, FL 33755